1.3mm Model Making Wire
Straightened and cut 1.3mm low carbon round wire for architectural models, robotics, and hobby applications. Non-plated, rust resistant through phosphate-free processing. Precisely fits HTS 7217.10.40 diameter and material requirements.
Import Duty Rates by Country of Origin
| Origin Country | MFN Rate | Ch.99 Surcharges | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | +17.5% | 17.5% |
| 🇲🇽Mexico | Free | +10.0% | 10% |
| 🇨🇦Canada | Free | +10.0% | 10% |
| 🇩🇪Germany | Free | +10.0% | 10% |
| 🇯🇵Japan | Free | +10.0% | 10% |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If concrete reinforcing quality
Deformed surface rebar wire uses specific Chapter 72 definitions.
If made into motor armatures
Electrical machinery parts classified by end-use function.
If incorporated in toys/games
Toy components classified in Chapter 95 regardless of material.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Pre-cut lengths still classified as wire unless complex forming occurred
• Bulk hobby packaging common; verify no plastic coatings on 'bare' wire claims
• Light oiling for rust prevention usually acceptable if < chapter note thresholds
Related Products under HTS 7217.10.40
0.8mm Low Carbon Steel Round Wire
Round wire of iron or nonalloy steel with less than 0.25% carbon content and a diameter of 0.8mm, not plated or coated. Used primarily for manufacturing springs and small wire forms in automotive and appliance industries. Falls under HTS 7217.10.40 due to its precise diameter under 1.5mm and low carbon composition.
0.5mm Annealed Low Carbon Wire
Soft annealed round steel wire, 0.5mm diameter, <0.25% carbon, non-plated for fine wire applications like electronics harnesses and jewelry making. The annealing process softens for better formability without affecting HTS classification. Meets 7217.10.40 criteria for size and composition.
1.0mm Spring Temper Steel Wire
Cold drawn spring quality wire, 1.0mm diameter, low carbon nonalloy steel, not plated or coated. Designed for small compression springs in toys, pens, and electronics with high tensile strength. HTS 7217.10.40 applies to its round form, size, and material purity.
0.9mm Industrial Binding Wire
Round low carbon steel wire (0.9mm), not plated, used for concrete reinforcement tying and packaging bundling. Meets strict <0.25% carbon and <1.5mm diameter specs of HTS 7217.10.40. Supplied in straight lengths or soft coils for construction sites.
1.4mm Fine Mesh Weaving Wire
High precision round wire 1.4mm diameter, <0.25% C nonalloy steel, polished but not coated for insect screening and filtration mesh. Critical tolerances maintained for uniform weaving. Classified HTS 7217.10.40 based on diameter limit and composition.
0.6mm Electronics Harness Wire
Ultra-fine 0.6mm diameter low carbon round steel wire for wiring harnesses in consumer electronics and automotive sensors. Bare, non-plated surface for subsequent insulation application. HTS 7217.10.40 designation due to sub-1.5mm size and carbon purity.