1.2mm Bright Drawn Steel Wire
Polished bright finish round wire, 1.2mm diameter, made from low carbon nonalloy steel (<0.25% C), not plated. Commonly used for binding wire, mesh production, and light-duty cables. Classified under HTS 7217.10.40 for its sub-1.5mm size and material specs.
Import Duty Rates by Country of Origin
| Origin Country | MFN Rate | Ch.99 Surcharges | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | +17.5% | 17.5% |
| 🇲🇽Mexico | Free | +10.0% | 10% |
| 🇨🇦Canada | Free | +10.0% | 10% |
| 🇩🇪Germany | Free | +10.0% | 10% |
| 🇯🇵Japan | Free | +10.0% | 10% |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If not round cross-section
Only round wire qualifies for .40 subheading; other shapes use .50 regardless of diameter.
If further worked into tubes or profiles
Chapter notes define 'further worked' products like clad or coated wire move out of simple wire headings.
If imported as strand or rope
Wire assembled into strands or cables classified as chain/barbed wire products in 7313.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Bright polished finish is permitted under 'whether or not polished' but document surface treatment to distinguish from plating
• Check for circular cross-section; oval or shaped wire falls outside round wire provisions
Related Products under HTS 7217.10.40
0.8mm Low Carbon Steel Round Wire
Round wire of iron or nonalloy steel with less than 0.25% carbon content and a diameter of 0.8mm, not plated or coated. Used primarily for manufacturing springs and small wire forms in automotive and appliance industries. Falls under HTS 7217.10.40 due to its precise diameter under 1.5mm and low carbon composition.
0.5mm Annealed Low Carbon Wire
Soft annealed round steel wire, 0.5mm diameter, <0.25% carbon, non-plated for fine wire applications like electronics harnesses and jewelry making. The annealing process softens for better formability without affecting HTS classification. Meets 7217.10.40 criteria for size and composition.
1.0mm Spring Temper Steel Wire
Cold drawn spring quality wire, 1.0mm diameter, low carbon nonalloy steel, not plated or coated. Designed for small compression springs in toys, pens, and electronics with high tensile strength. HTS 7217.10.40 applies to its round form, size, and material purity.
0.9mm Industrial Binding Wire
Round low carbon steel wire (0.9mm), not plated, used for concrete reinforcement tying and packaging bundling. Meets strict <0.25% carbon and <1.5mm diameter specs of HTS 7217.10.40. Supplied in straight lengths or soft coils for construction sites.
1.4mm Fine Mesh Weaving Wire
High precision round wire 1.4mm diameter, <0.25% C nonalloy steel, polished but not coated for insect screening and filtration mesh. Critical tolerances maintained for uniform weaving. Classified HTS 7217.10.40 based on diameter limit and composition.
0.6mm Electronics Harness Wire
Ultra-fine 0.6mm diameter low carbon round steel wire for wiring harnesses in consumer electronics and automotive sensors. Bare, non-plated surface for subsequent insulation application. HTS 7217.10.40 designation due to sub-1.5mm size and carbon purity.