Hot-Rolled L80x80x8 Equal Leg Angle
Equal-leg L section exactly 80 mm height x 80 mm width x 8 mm thick, hot-rolled nonalloy steel, no further working. Precisely matches HTS 7216.40.00 for minimum 80 mm height L sections. Suited for light structural framing.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If measured under 80 mm
Strict height threshold; sub-80 mm L sections go to 7216.21 general category.
If burnished or clad
Burnishing or metal cladding counts as further worked per Chapter note definition.
If sold as tube fittings set
Packaged with fittings for tube/pipe assembly moves to Chapter 73 fittings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Measure height precisely; CBP may reclassify borderline 80 mm items to lower subheadings
• Avoid any oiling or temporary coatings that could be seen as 'chemical surface treatments.',Prepare for quota restrictions if applicable to specific steel shapes from certain countries
Related Products under HTS 7216.40.00
Hot-Rolled T100x50x8 Light Tee Section
Lightweight T profile 100 mm high x 50 mm flange x 8 mm thick, nonalloy hot-rolled steel. HTS 7216.40.00 applies as T section over 80 mm not further worked. Used for purlins and secondary framing.
Hot-Rolled L100x100x10 Steel Angle
An L-shaped structural steel section with 100 mm leg lengths and 10 mm thickness, produced by hot-rolling nonalloy steel. It measures over 80 mm in height and lacks further working beyond hot-rolling, fitting HTS 7216.40.00 as an L section of iron or nonalloy steel. Used primarily in construction framing and supports.
Hot-Rolled T150x75x12 Steel Tee Section
A T-shaped nonalloy steel beam with 150 mm height, 75 mm flange width, and 12 mm thickness, hot-rolled without further processing. Qualifies under HTS 7216.40.00 due to its T profile, height over 80 mm, and lack of additional working. Commonly used in roof trusses and framing.
Hot-Extruded L200x200x20 Structural Angle
Large L-section angle of nonalloy steel, 200 mm per leg by 20 mm thick, produced via hot extrusion with no further working. Meets HTS 7216.40.00 criteria for L sections over 80 mm height from iron/nonalloy steel. Ideal for heavy industrial frameworks and bridges.
Hot-Rolled T200x100x16 Tee Beam Section
Tee section hot-rolled from nonalloy steel, featuring 200 mm stem height exceeding 80 mm, 100 mm flange, 16 mm web thickness. Classed in HTS 7216.40.00 as a non-further-worked T section of iron/nonalloy steel. Applied in floor joists and structural supports.
ASTM A36 L125x125x12 Hot-Rolled Angle
Standard ASTM A36 nonalloy steel L angle, 125 mm legs x 12 mm thick, hot-rolled without additional processing. Fits HTS 7216.40.00 for L sections over 80 mm height not further worked. Widely used in building columns and braces.