High-Strength Steel Strip 6mm Thick 450mm Wide
Hot-rolled high-strength steel strip, 6mm thick and 450mm wide, with yield strength exceeding 355 MPa, not further worked. Meets U.S. note (a) definition for high-strength steel of 3mm+ thickness. Falls under HTS 7211.14.0030 as nonalloy, flat-rolled product under 600mm width.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness of 10 mm or more
Thicker high-strength steel plates in this category have separate statistical breakout within the same heading.
If alloy steel instead of nonalloy
Alloy high-strength steel flat products shift to Chapter 72 heading 7225, regardless of width.
If cold-rolled rather than hot-rolled
Cold-rolled high-strength steel under 600mm width classified under 7210, not hot-rolled 7211.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide chemical composition and mechanical test reports confirming nonalloy status and high-strength properties
• Avoid common pitfall of edge trimming which may be seen as 'further worked' - import in as-rolled condition
• Label shipments clearly with exact dimensions to match 7211.14.0030 criteria during customs exam
Related Products under HTS 7211.14.00.30
High-Strength Hot-Rolled Steel Plate 10mm Thick 500mm Wide
Flat-rolled nonalloy steel plate of 10mm thickness and 500mm width, meeting high-strength steel criteria with minimum yield point of 355 MPa for thicknesses 3mm or more. Not further worked beyond hot-rolling, not clad, plated or coated. Classified under 7211.14.0030 due to its high-strength steel definition per Chapter 72 note (a) and specific dimensions.
Grade 50 High-Strength Steel Plate 12mm Thick 300mm Wide
ASTM A572 Grade 50 high-strength low-alloy (but nonalloy per HTS) steel plate, hot-rolled 12mm x 300mm, minimum yield 345 MPa (meets 355 MPa criteria). Not further worked, ideal for heavy equipment frames. Fits 7211.14.0030 exactly.
Hot-Rolled High-Strength Steel Band 7mm x 580mm
High-strength steel band in straight lengths, 7mm thick x 580mm wide (just under 600mm limit), yield strength 355 MPa+, hot-rolled only. Used for strapping and reinforcement. HTS 7211.14.0030 per dimensions and steel type.
High-Strength Steel Sheet for Pressure Vessels 4.8mm Thick
Hot-rolled high-strength steel sheet 4.8mm thick x 500mm wide for pressure vessel fabrication, minimum yield 355 MPa. Nonalloy composition, no coatings or cladding. Classifies under 7211.14.0030 due to thickness over 4.75mm threshold.
High-Strength Steel Blank 9mm x 200mm for Machining
Hot-rolled high-strength steel blanks 9mm thick x 200mm wide, 355 MPa yield minimum, supplied rough for machining into parts. Not further worked beyond rolling, nonalloy. HTS 7211.14.0030 classification applies.
AH36 High-Strength Structural Steel Sheet 5mm Thick
AH36 grade hot-rolled steel sheet, 5mm thick x 550mm wide, high-strength steel with minimum 355 MPa yield point for shipbuilding and structural use. Not clad, plated, or coated, not further worked than hot-rolled. Precisely matches HTS 7211.14.0030 per Chapter 72 definitions.