Cold-Rolled Low-Carbon Steel Coil 0.45mm for Electrical Boxes
Low-carbon nonalloy steel coil cold-rolled to 0.45mm thickness, 650mm wide, for junction box fabrication. Matches HTS 7209.18.60.90: flat-rolled, cold-reduced, in coils, <0.5mm, not clad/plated/coated/further worked, width 600mm+.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If electrical sheet quality alloy steel
Nonalloy for 7209; electrical alloys with silicon/Cr per notes go to 7225 specialized alloys.
If hot-rolled equivalent under 0.5mm
Process defines heading; hot-rolled thin coils in 7208, cold-reduction for 7209.
If over 10% alloying elements
Chapter 72 nonalloy limit; higher alloys to 7212/7225 based on composition.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Mill test reports essential for carbon content (<0.3% typical for nonalloy) and yield strength below high-strength note (a)
• Width measurement critical; under 600mm reclassifies entirely to Chapter 72 narrow products
• No rust allowance per note; reject discolored lots or face full duties
Related Products under HTS 7209.18.60.90
Cold-Rolled Nonalloy Steel Coil 0.3mm Thick for Appliance Panels
Thin cold-rolled steel coil, 0.3mm thick and 800mm wide, made from nonalloy steel, used for manufacturing refrigerator and washer panels. Classified under HTS 7209.18.60.90 as flat-rolled nonalloy steel over 600mm wide, cold-rolled, in coils, under 0.5mm thick, not further worked, clad, plated, or coated. Meets chapter definitions for basic cold-reduced products without surface treatments.
Ultra-Thin 0.2mm Cold-Rolled Steel Coil for Metal Furniture
0.2mm thick cold-rolled nonalloy steel coil, 700mm wide, suited for filing cabinet and desk components. Under HTS 7209.18.60.90 for flat-rolled iron/nonalloy steel, cold-rolled in coils, thickness <0.5mm, not further worked or coated. Basic mill finish without Chapter 72 prohibited treatments.
0.1mm Cold-Reduced Deep Drawing Steel Coil
Extra-thin 0.1mm cold-rolled deep drawing quality nonalloy steel coil, 1200mm wide, for stamped metal lids. HTS 7209.18.60.90 for cold-rolled coils <0.5mm thick, nonalloy, no further working/coatings, per chapter exclusions.
0.48mm Commercial Quality Cold-Rolled Steel Coil for Shelving
Commercial grade cold-rolled nonalloy steel coil at 0.48mm thickness, 750mm width, for retail shelving punch-outs. Fits 7209.18.60.90 as basic cold-reduced product without Chapter 72 further working or special steel notes.
Cold-Rolled Stripper Steel Coil 0.25mm for Packaging
0.25mm cold-rolled nonalloy stripper steel coil, 600mm wide, for can end stock pre-forming. HTS 7209.18.60.90: thin cold-rolled coil, no cladding/coating/further work.
0.42mm Cold-Rolled Steel for Lockers and Cabinets
Cabinet-grade 0.42mm cold-rolled nonalloy coil, 850mm wide. 7209.18.60.90 for uncoated cold-reduced.