High-Strength Cold-Rolled Steel Coil for Automotive Chassis
Cold-rolled high-strength steel coil, thickness 1.5 mm, width 1200 mm, minimum yield point 355 MPa, used in automotive chassis components. Classified under 7209.16.0060 as flat-rolled nonalloy high-strength steel, cold-rolled in coils, thickness 1-3 mm, not further worked. Meets chapter note (a) definition for high-strength steel over 3 mm equivalent strength.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If thickness of 1 mm or less
Thinner cold-rolled high-strength steel coils fall under the subheading for thickness not exceeding 1 mm.
If further worked with surface treatment like coating
Chapter defines 'further worked' to include coatings, moving it from 7209 to 7211.
If alloy steel rather than nonalloy
Alloy steels are classified in Chapter 72 heading 7225, not nonalloy steel heading 7209.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Certify minimum yield strength documentation to qualify as high-strength steel per chapter note (a)
• Verify cold-rolled status and absence of cladding, plating or coating to avoid reclassification
Related Products under HTS 7209.16.00.60
High-Strength Steel Coil for Construction Equipment Frames
Cold-rolled nonalloy steel coil, 2.2 mm thick, 1500 mm wide, yield strength 380 MPa, for heavy equipment frames. Fits 7209.16.0060 as high-strength steel per note (a), cold-rolled in coils, not plated or coated. Used in construction machinery structural components.
Automotive Grade High-Strength Steel CR Coil 1.8 mm
Cold-reduced high-strength steel coil for car body panels and reinforcements, thickness 1.8 mm, width 1400 mm, yield 275 MPa minimum. Under HTS 7209.16.0060 as nonalloy high-strength steel, cold-rolled, in coils, thickness exceeding 1 mm but <3 mm, other category. Not clad, plated or coated.
High-Strength Steel Coil for Agricultural Machinery
Cold-rolled high-strength nonalloy steel coil, 2.5 mm thickness, 1100 mm width, 360 MPa yield, for tractor and harvester frames. Classified 7209.16.0060 meeting high-strength steel criteria, in coils, not further worked than cold-rolled. Essential for durable ag equipment.
DP600 High-Strength Cold-Rolled Steel Coil
Dual-phase DP600 grade high-strength steel coil, cold-rolled, 1.6 mm thick, 1300 mm wide, yield strength exceeding 355 MPa. HTS 7209.16.0060 for other high-strength flat-rolled nonalloy steel coils, thickness 1-3 mm, not coated. Used in crash-resistant vehicle structures.
High-Strength Steel CR Coil for Solar Panel Frames
Cold-rolled high-strength steel coil 2.0 mm thick, 900 mm wide, 340 MPa yield, for renewable energy panel mounting frames. Under 7209.16.0060 as other high-strength nonalloy steel, flat-rolled in coils ≥600 mm wide, 1-3 mm thick. Not plated or further worked.
Grade 80 High-Strength Cold-Rolled Steel Coil
Grade 80 high-strength low-alloy equivalent nonalloy steel coil, cold-rolled 1.2 mm, 1600 mm wide, minimum yield 550 MPa. Classifies 7209.16.0060 as high-strength steel per note (a) thickness/strength criteria, in coils, not clad. For structural reinforcements.