Skin-Passed Hot-Rolled Steel Sheet 14 Gauge
14 gauge hot-rolled steel with light skin-pass for flatness, nonalloy, 72 inch width. Borderline HTS 7208.90.00.00 if skin-pass minimal (not true cold-rolling), uncoated. Improves surface for painting preparation in appliances.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If skin-pass constitutes cold-rolling
Any significant cold reduction changes from hot-rolled to cold-rolled heading.
If skin-passed then plated
Post skin-pass plating follows coated hot-rolled classification.
If certain pickled skin-passed specs
Pickling plus skin-pass has specific statistical subheading.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document skin-pass reduction <1% to distinguish from cold-rolling
• Provide reduction schedule showing primarily hot-rolled process
• CBP may measure flatness/surface to verify skin-pass vs cold-rolled
Related Products under HTS 7208.90.00.00
ASTM A36 Hot-Rolled Steel Plate 1/4 Inch Thick
Hot-rolled flat-rolled steel plate made from nonalloy A36 grade steel, measuring 48 inches wide by 96 inches long and 1/4 inch thick. This product falls under HTS 7208.90.00.00 as it is a hot-rolled, nonalloy steel product over 600 mm wide, not clad, plated, or coated. Commonly used in structural fabrication and general construction.
SAE 1018 Hot-Rolled Steel Sheet 10 Gauge
Hot-rolled steel sheet in SAE 1018 nonalloy grade, 10 gauge thickness (approx 3.4 mm), width 60 inches, used for machinery bases. Classified under 7208.90.00.00 for hot-rolled iron/nonalloy steel products ≥600 mm wide without cladding or coating. The descaled mill finish distinguishes it from pickled/oiled sheets.
Hot-Rolled Floor Plate 1/2 Inch Thick Diamond Pattern
Nonalloy steel floor plate with raised diamond pattern formed during hot-rolling, 1/2 inch thick, 72 inches wide. Falls under HTS 7208.90.00.00 as 'other' hot-rolled flat products of iron/nonalloy steel ≥600 mm, not clad/coated (patterns in relief excluded by note). Used for trailer flooring and platforms.
ASTM A572 Grade 50 Hot-Rolled Steel Sheet
Grade 50 high-strength low-alloy steel sheet, hot-rolled, 3/16 inch thick, 60 inches wide, nonalloy per Chapter 72 definitions. HTS 7208.90.00.00 applies to this hot-rolled flat-rolled nonalloy steel product ≥600 mm wide without surface treatments. Suitable for bridge girders and heavy equipment.
Commercial Quality Hot-Rolled Steel Coil 4 mm Thick
Nonalloy commercial quality (CQ) hot-rolled steel in coil form, 4 mm thick, inner width 610 mm for slitting. Classified HTS 7208.90.00.00 as hot-rolled flat-rolled iron/nonalloy steel ≥600 mm, not clad/plated/coated. Standard grade for ductwork and light fabrication.
Hot-Rolled Checkered Steel Plate 3/8 Inch
Nonalloy checkered pattern steel plate hot-rolled with embossed surface for traction, 3/8 inch thick, 96 x 240 inches. HTS 7208.90.00.00 for other hot-rolled flat-rolled products of iron/nonalloy steel ≥600 mm wide. Used in walkways and ramps where slip-resistance needed.