Hot-Rolled Lenticular Steel Sheet 3.75mm
Flat-rolled iron or nonalloy steel sheet with lenticular raised patterns, 3.75mm thick, 1000mm wide, used for decorative cladding. HTS 7208.40.60 applies as hot-rolled, not in coils, with relief patterns, thickness <4.75mm.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If sem-finished or not fully rolled
Less processed ingots/blooms move to earlier Chapter 72 headings.
If further worked than hot-rolled
Polishing or chemical treatments constitute 'further worked' per Chapter definition.
If alloy steel composition
Exceeding nonalloy limits (e.g., added chromium) shifts to Chapter 72 alloy headings.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Include photos or diagrams showing patterns produced solely by hot-rolling deformation
• Certify carbon content under 0.6% to confirm nonalloy steel status
• Check for rust discoloration; no duty allowance per Chapter Note on iron/steel entry
Related Products under HTS 7208.40.60
Hot-Rolled Checkered Steel Plate 3mm Thick
A flat-rolled nonalloy steel plate, 3mm thick and 1200mm wide, featuring hot-rolled embossed patterns in relief for enhanced grip. Classified under HTS 7208.40.60 as hot-rolled, not in coils, not further worked beyond hot-rolling, with patterns in relief, and thickness under 4.75mm.
Raised Pattern Floor Steel Sheet 2.5mm
Nonalloy steel sheet, 2.5mm thick, 1500mm wide, with hot-rolled diamond tread patterns for industrial flooring. Fits HTS 7208.40.60 due to hot-rolled state, not coiled, patterns in relief, and thickness below 4.75mm.
Embosed Grip Steel Plate 1.8mm Thick
Thin hot-rolled nonalloy steel plate with embossed grip patterns for machinery walkways, 1.8mm thick, 800mm wide. Classified in 7208.40.60 for width over 600mm, hot-rolled relief patterns, not coiled or further worked.
Corrugated Hot-Rolled Steel Panel 3.2mm
Corrugated pattern nonalloy steel sheet, hot-rolled with wave relief, 3.2mm thick, 1600mm wide for roofing applications. Meets HTS 7208.40.60: flat-rolled >600mm, hot-rolled patterns, <4.75mm thick, not coiled.
Diamond Treadplate Steel 4.0mm Thick
Hot-rolled diamond pattern steel treadplate for truck beds, 4.0mm thick, 1400mm wide, nonalloy composition. HTS 7208.40.60 due to relief patterns from hot-rolling, not further worked, thickness under 4.75mm.
Ribbed Hot-Rolled Steel Sheet 2.8mm
Ribbed pattern nonalloy steel sheet for stair treads, hot-rolled 2.8mm thick, 900mm wide. Falls under 7208.40.60 as flat-rolled >600mm wide, patterns in relief, not coiled or coated.