Hot-Rolled Steel Service Coil 3.9mm for Trailer Manufacturing
Service center quality hot-rolled nonalloy steel coil, 3.9 mm thickness, 900 mm wide minimum, in coils uncoated. Meets all criteria for HTS 7208.38.00 including no further working beyond hot-rolling. Common in trailer chassis and underbody fabrication.
Import Duty Rates by Country of Origin
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If chemically treated like phosphatized
Chemical surface treatments per Chapter 72 notes qualify as 'further worked,' moving to 7208.43.
If shaped into concrete reinforcing bars/rods
Products with rolling deformations matching U.S. Note (c) classify as reinforcing bars in 7213.
If in universal mill plate form, not coils
Universal mill plates (Note b) not in coils go to 7208.10, differing from coiled specification.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide service coil edge trimming details if any (must not alter classification); certify flatness tolerances; inspect for allowable surface scale per industry standards
Related Products under HTS 7208.38.00
Hot-Rolled Nonalloy Steel Coil 3.5mm Thick for General Construction
Hot-rolled flat-rolled steel coil made of nonalloy steel, measuring 3.5 mm thick and over 600 mm wide, supplied in coils without cladding, plating, or coating. This product is not further worked beyond hot-rolling, fitting precisely under HTS 7208.38.00 due to its specified thickness range of 3 mm or more but less than 4.75 mm. Commonly used in structural beams and panels for building construction.
HRPO Steel Coil 3.2mm Thick for Automotive Panel Stamping
Hot-rolled pickled and oiled (HRPO) nonalloy steel coil, 3.2 mm thick, width exceeding 600 mm, in coil form without plating or cladding. While pickled and oiled, this surface cleaning does not constitute 'further worked' per Chapter 72 notes, keeping it classified under HTS 7208.38.00 for its thickness. Ideal for stamping car body panels and chassis components.
Hot-Rolled Steel Coil 4.0mm Thick for Pipe Manufacturing
Nonalloy steel hot-rolled coil at 4.0 mm thickness, over 600 mm wide, not clad or coated, and not further worked beyond hot-rolling. Meets HTS 7208.38.00 exact specifications for thickness (3-4.75 mm) and form. Primarily used as feedstock for welded steel pipe production in oil/gas and water lines.
Nonalloy Steel Hot Band Coil 3.8mm for Heavy Machinery Frames
Hot band coil of nonalloy steel, 3.8 mm thick, width 1,200 mm, in coiled form, hot-rolled only without additional processing. Classifies under HTS 7208.38.00 for its precise thickness and uncoated, unclad state. Used in fabricating frames for agricultural and industrial machinery.
Commercial Quality Hot-Rolled Steel Coil 3.4mm for Storage Tanks
Commercial grade nonalloy hot-rolled steel coil, 3.4 mm thickness, over 600 mm wide, in coils and free of cladding or coatings. Fits HTS 7208.38.00 due to thickness specs and lack of further working. Employed in fabricating fuel and water storage tanks.
Hot-Rolled Low Carbon Steel Coil 3.6mm for Shipbuilding Plates
Low carbon nonalloy steel hot-rolled coil, 3.6 mm thick, 1,500 mm wide, uncoated and in coil form only hot-rolled. Precisely matches HTS 7208.38.00 thickness and processing criteria. Suited for ship hull plating and marine structures after decoiling.