Steel Bloom 250x250mm
Large rectangular steel bloom 250x250mm cross-section, primary form from continuous casting process, destined for rolling into heavy sections or plates. HTS 7206.90.00.00 covers such nonalloy steel primary forms excluding standard ingots. Meets definition of primary form before hot-rolling.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If qualifies as semi-finished
Blooms with specific dimensions or basic rolling may enter as angle/shape semi-finished products under 7207.
If hot-rolled into flat products
Any hot-rolling into flat-rolled form shifts to heading 7208 for nonalloy steel.
If industrial forged bars from blooms
If forged rather than rolled, may classify under forged bars/rods of 7214.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• 1
• Submit chemical analysis reports proving nonalloy status per Chapter 72 notes. 2
• Clearly mark as 'primary form - not further worked' to prevent 7207 misclassification. 3
• Check for Section 232 tariffs on steel primary forms which may apply additionally
Related Products under HTS 7206.90.00.00
Steel Billet 150x150mm
A semi-finished square steel billet measuring 150mm x 150mm, produced by continuous casting from nonalloy steel, used as primary form for further rolling into bars or shapes. Classified under HTS 7206.90.00.00 as 'other' primary forms of nonalloy steel excluding ingots. Not further worked beyond basic casting.
Steel Slab 200mm Thick
Flat rectangular steel slab approximately 200mm thick x 1.5m wide, primary form for plate/sheet production via hot-rolling. Classifies in HTS 7206.90.00.00 as other primary forms of nonalloy iron/steel excluding remelting ingots. Surface may have scale but no further working per Chapter notes.
Nonalloy Steel Rundown 180mm Diameter
Cylindrical steel rundown 180mm diameter, semi-finished primary form produced by continuous casting for wire rod production. HTS 7206.90.00.00 for other primary forms excluding iron of 7203. Distinguished from wire rod by lack of reduction/elongation.
Steel Cylindrical Ingot Mold Casting
Large cylindrical steel casting from ingot mold process, irregular surfaces typical of primary steel forms before remelting or rolling. HTS 7206.90.00.00 captures such other primary forms not meeting standard ingot definitions. Used in specialty steelmaking.
Continuous Cast Steel Strand Section
Steel strand section from continuous casting machine, cut to length as primary form prior to reheating for rolling. Classifies under HTS 7206.90.00.00 as other nonalloy steel primary forms. Scale-covered surface indicates no further working.
Nonalloy Steel Pig
Block-shaped steel pig cast in sand molds, traditional primary form for remelting in open hearth furnaces. HTS 7206.90.00.00 for such other primary nonalloy steel forms excluding modern ingots. Common in developing steel industries.