Palladium Wire 0.5mm Diameter
Fine palladium wire drawn to 0.5mm diameter, in coils for further fabrication, considered semimanufactured. Fits HTS 7110.29.00.00 as 'other' non-powder palladium forms, excluding specific shapes like sheet or strip. Applied in electronics contacts and medical devices.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If in sheet, strip, or specific semimanufactured forms
Subheading 7110.19.50 covers enumerated semimanufactured platinum/palladium alloys, excluding 'other'.
If copper-based alloy with minor palladium
Alloys under 2% precious metal fall to base metal chapters like 74 for copper, per note 5 exclusion.
If insulated for electrical use
Insulated palladium wire is classified as insulated electrical conductors in Chapter 85.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right HTS code — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Measure and document exact diameter/length to avoid confusion with foil (under 0.18mm) or rod classifications
• Certify as non-clad per chapter note 7; plated wire goes to Chapter 71 clad provisions or Chapter 83
Related Products under HTS 7110.29.00.00
Palladium Rod 2mm Diameter
Drawn rod 2mm dia for evaporation sources. Other semimanufactured 7110.29.00.00. Vacuum deposition use.
Palladium Alloy Wire 99Pd-1Pt
Wire alloy 99% Pd 1% Pt, below 2% Pt threshold. Classed as Pd other in 7110.29.00.00 per note 5. Thermocouple grade.
Unwrought Palladium Bar
A bar of pure palladium in unwrought form, cast directly from molten metal without further processing into sheets or wires. It falls under HTS 7110.29.00.00 as 'other' palladium in unwrought form, distinct from powder or specific semimanufactured shapes like bars over certain dimensions. Used primarily in investment and industrial alloy production.
Palladium Sponge
Porous palladium sponge produced by precipitation and reduction, a semimanufactured intermediate form before pressing into ingots. Classified under HTS 7110.29.00.00 as 'other' palladium, not qualifying as powder per subheading note (less than 90% through 0.5mm sieve). Commonly used in chemical catalysis and hydrogen purification.
Palladium Granules 1-2mm
Atomized palladium granules sized 1-2mm, irregular semimanufactured form for melting stocks. HTS 7110.29.00.00 'other' as they fail powder sieve test (not 90%+ through 0.5mm). Used in dental alloys and investment casting.
Palladium Strip 10mm Wide
Narrow palladium strip rolled to 10mm width for thermocouple sheaths. HTS 7110.29.00.00 covers this 'other' semimanufactured form. Valued in high-temp sensing.