White Primed MDF Door Jamb Molding
Medium-density fiberboard (MDF) molding specifically profiled for door jamb applications, with factory-applied white primer. Falls under HTS 4411.93.90.10 as standard wood molding due to its fiberboard composition and density range of 0.5-0.8 g/cm³. Commonly used in interior door framing for new construction and renovations.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If density exceeds 0.8 g/cm³
Higher density fiberboard enters subheading 4411.94, typically commanding different duty treatment.
If considered finished woodwork rather than molding stock
Pre-machined to exact door dimensions may qualify as 'other wood articles' under 4421 instead of molding.
If in plywood form rather than fiberboard
Plywood-based moldings with veneered surfaces fall under heading 4412 for laminated wood products.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Provide cross-sectional diagrams showing jamb-specific profiles to prevent reclassification as generic fiberboard
• Ensure TSCA formaldehyde labeling on packaging for composite wood products imported into the US
• Declare exact density measurements to avoid disputes over subheading 4411.93 vs. 4411.94 boundaries
Related Products under HTS 4411.93.90.10
Primed Pine Standard Wood Baseboard Molding
This fiberboard baseboard molding, with a density between 0.5 and 0.8 g/cm³, is primed for painting and used to cover wall-floor junctions in residential construction. Classified under HTS 4411.93.90.10 as standard wood molding made from medium-density fiberboard (MDF) rather than solid wood. The profiled edges and standard dimensions distinguish it from other fiberboard products.
Oak Grain MDF Crown Molding
Crown molding made from medium-density fiberboard with embossed oak grain texture and primer coating. Classified in HTS 4411.93.90.10 as standard wood molding within the specified density range, distinguished by its decorative ceiling-wall profile. Ideal for architectural trim in homes and commercial spaces.
Primed Finger-Joint Pine Casing Molding
Fiberboard casing molding with finger-joint construction and white primer, density 0.5-0.8 g/cm³ for window and door casings. HTS 4411.93.90.10 applies as standard wood molding, not solid lumber, due to reconstituted wood fibers. Provides smooth, paint-ready surface for trim applications.
Colonial Style MDF Chair Rail Molding
Classic colonial profile chair rail molding manufactured from medium-density fiberboard (0.5-0.8 g/cm³). Specifically classified under HTS 4411.93.90.10 as standard wood molding for protecting walls from chair backs. Factory-primed for easy finishing in traditional interior designs.
Smooth Primed MDF S4S Trim Board
S4S (surfaced four sides) trim board made from medium-density fiberboard, primed smooth for painting. HTS 4411.93.90.10 designation as standard wood molding due to density specs and rectangular profile with eased edges. Used for base trim, window stools, and general interior millwork.