S-P-F Nickel Gap Siding
Spruce-Pine-Fir siding with precise 1/8-inch nickel gap V-groove for modern accent walls. Mixed coniferous species continuously shaped per subheading note, classified HTS 4409.10.1080.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If before edge profiling completed
S-P-F lumber pre-shaping remains in sawn wood heading 4407.
If beaded ceiling panels variant
Ceiling applications with beads become separate panel category.
If custom architectural moldings
Specialty profiles for non-siding use shift to other wood articles.
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• S-P-F mixed species documentation per 4407.13 note applies to shaped products
• Specify gap tolerance in technical specs for profile verification
• Interior vs exterior use affects marking requirements but not HTS primarily
Related Products under HTS 4409.10.10.80
Spruce Shiplap Siding Boards
Spruce lumber cut into shiplap siding with rebated overlapping edges for weather-tight exterior cladding. This coniferous product is end-jointed and sanded, fitting HTS 4409.10.1080 as 'other' siding due to its continuous edge shaping for construction use.
Douglas Fir Chamfered Siding
Douglas fir siding boards with chamfered edges to prevent splintering and aid installation. Continuously shaped coniferous wood for exterior use fits HTS 4409.10.1080 as other profiled siding.
Larch Molded Edge Siding
Larch siding with molded edge profiles imitating traditional clapboard. Sanded coniferous wood continuously shaped qualifies as HTS 4409.10.1080 other wood siding.
Pine Tongue-and-Groove Siding
Pine wood siding panels continuously shaped with tongue-and-groove edges for seamless interlocking installation on exterior walls. This coniferous wood product is planed and sanded but not assembled, classifying under HTS 4409.10.1080 as 'other' wood siding due to its profiled edges and coniferous origin.
Fir V-Joint Siding Panels
Fir wood siding featuring V-jointed edges for aesthetic shadow lines in rustic cabin exteriors. Coniferous origin with machined V-profiles along faces and edges qualifies under HTS 4409.10.1080 as non-pine wood siding continuously shaped.
Cedar Beaded Siding
Western red cedar siding with beaded edges for decorative trim applications in coastal homes. This profiled coniferous wood product meets HTS 4409.10.1080 criteria as 'other' siding continuously shaped along edges and sanded for finish.