End-Jointed Mahogany Finger-Joint Blocks 12mm Thick
Swietenia spp. mahogany blocks assembled via finger-jointing, sanded, thickness over 6mm for dimensional stability. HTS 4407.21.00.00 covers end-jointed tropical mahogany sawn wood. Used for stair treads, shelving, and mold stock.
Import Duty Rates by Country of Origin
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If non-coniferous with tongue-and-groove joints
Wood with specific profiles or joints moves to 4409 worked wood category
If cut into statuettes or ornamental carvings
Artistically worked mahogany pieces classified as wood carvings under 4420
If in rough form with bark still attached
Rough wood not sawn/chipped/peeled falls under earlier Chapter 44 headings
Not sure which classification is right?
Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.
Import Tips & Compliance
• Document finger-joint specs to remain in 4407 vs advanced assembly in 4418; test for binder content if agglomerated; ensure uniform thickness measurement
Related Products under HTS 4407.21.00.00
Sawn Genuine Mahogany Lumber (Swietenia macrophylla)
Thickness exceeding 6 mm mahogany wood sawn lengthwise from Swietenia macrophylla trees, typically planed and sanded for woodworking. Classified under HTS 4407.21.00.00 as tropical mahogany lumber of specified thickness from controlled sources. Used primarily for high-end furniture and cabinetry.
Planed Mahogany (Swietenia mahagoni) Boards 8mm Thick
End-jointed and sanded boards from Cuban mahogany (Swietenia mahagoni) exceeding 6mm thickness, sawn lengthwise for fine joinery. Fits HTS 4407.21.00.00 due to species classification as mahogany tropical wood. Ideal for musical instrument bodies like guitar backs.
Sliced Mahogany Flitch for Veneer Preparation
Lengthwise sliced Swietenia spp. flitches over 6mm thick, lightly sanded but not reduced to thin veneer sheets. HTS 4407.21.00.00 applies as sawn/sliced tropical mahogany exceeding veneer thickness limits. Commonly resliced into quarter-sawn ribbon grain veneers.
Quarter-Sawn Mahogany Lumber for Boat Building
Quarter-sawn Swietenia macrophylla planks exceeding 6mm, planed for marine applications with high rot resistance. Classified HTS 4407.21.00.00 as tropical mahogany sawn wood of required thickness. Used in classic wooden boat planking and trim.
Sanded Ribbon Grain Mahogany for Cabinet Doors
Ribbon figure mahogany (Swietenia macrophylla) sawn and sanded to 10mm thickness for raised panel doors. Precisely fits HTS 4407.21.00.00 as planed/sanded tropical mahogany lumber. Premium figure prized by custom cabinetmakers.
Mahogany Stair Tread Blanks Sawn Lengthwise
Pre-cut Swietenia mahogany blanks over 6mm thick, planed top and bottom for architectural millwork. HTS 4407.21.00.00 classification for tropical mahogany sawn lumber. Standard 36-inch lengths for residential stair nosings.