Cut Tobacco Stems for Pipe Blending

These are cut tobacco stems derived from flue-cured tobacco, processed by cutting into small pieces suitable for blending into pipe tobacco mixtures. Classified under HTS 2401.30.35.90 as cut tobacco refuse (stems) entered pursuant to U.S. Note 5 quota provisions, the stems serve as a low-cost extender in tobacco products without further manufacturing.

Import Duty Rates by Country of Origin

Origin CountryMFN RateCh.99 SurchargesTotal Effective Rate
🇨🇳ChinaFree+35.0%35%
🇲🇽MexicoFree+10.0%10%
🇨🇦CanadaFree+10.0%10%
🇩🇪GermanyFree+10.0%10%
🇯🇵JapanFree+10.0%10%

Alternative Classifications

This product could be classified differently depending on its characteristics or intended use.

2401.30.37.90Same rate: 35%

If not entered pursuant to U.S. Note 5 quota provisions

Tobacco stems outside quota limits fall under the general 'other' subheading for non-quota refuse.

2401.10.63Lower: 17.5% vs 35%

If whole or threshed stems rather than cut/ground

Unprocessed or threshed stems (not pulverized) classify as unmanufactured tobacco under different refuse provisions.

2403.99.60Same rate: 35%

If further processed into reconstituted sheet for cigarettes

Stems made into manufactured products like recon sheet move to Chapter 24 heading 2403 for processed tobacco.

Not sure which classification is right?

Our AI classifier can analyze your specific product and recommend the correct HTS code with confidence.

Import Tips & Compliance

Verify origin country eligibility under U.S

Note 5 quotas (e.g

Brazil up to 80,200 MT annually) and obtain USTR approval if needed

Provide lab analysis confirming stems are cut/ground/pulverized tobacco refuse, not leaf, to avoid reclassification

Exclude products from Canada, Israel, or Mexico as they bypass quota subheadings; track aggregate entries from Sep 13 to Sep 12