Oscilloscope Probe Positioner Arm
A flexible positioning arm for hands-free oscilloscope probe placement during long-duration measurements. It clamp-mounts to the oscilloscope or bench with locking joints for stable positioning. This workstation accessory is dedicated to oscilloscope use, falling under tariff item 9030.90.00.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | — | Free |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If the arm is a general-purpose metal clamp not specific to oscilloscopes
Articles of iron or steel, not elsewhere specified, could apply if the arm is not dedicated to oscilloscope use.
If the arm is used with other measuring instruments
Parts and accessories for measuring or checking instruments of heading 90.31 could apply if not specific to oscilloscopes.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Classify the positioner as an accessory for oscilloscopes under 9030.90.00
• If the arm is a general-purpose laboratory clamp, it may be classified under a different heading
• Provide evidence of its specific design for oscilloscope probing to avoid reclassification
Related Products under Tariff item 9030.90.00
4-Channel Analog Front-End PCA for Benchtop Scopes
A multi-channel printed circuit assembly with track/hold amplifiers and 12-bit ADCs, designed specifically for 4-channel benchtop oscilloscopes up to 500MHz. This PCA is a dedicated part for oscilloscopes of subheading 9030.10, as it conditions and digitizes analog signals for measurement.
9030.82 Ionizing Radiation Control PCA
A control printed circuit assembly for apparatus detecting cosmic and other ionizing radiations under heading 90.30. It manages power, data acquisition, and alarms for radiation detection instruments. As a dedicated part for ionizing radiation measurement apparatus, it falls under tariff item 9030.90.00.
Active FET Oscilloscope Probe
A low-noise active FET probe for high-impedance oscilloscope measurements up to 1GHz bandwidth, powered via scope auxiliary port. This probe is an accessory for oscilloscopes of subheading 9030.10, enhancing measurement capabilities.
Bertscope Bit Error Rate PCA
A printed circuit assembly for bit error rate testing in high-speed oscilloscopes of heading 90.30. It generates patterns and measures electrical eye diagrams for signal integrity analysis. As a dedicated part for oscilloscopes, it is classified under tariff item 9030.90.00.
BNC Feedthrough Termination 50 Ohm
A 50-ohm BNC feedthrough terminator for oscilloscope inputs, preventing signal reflections and protecting front-end amplifiers. This accessory is used with oscilloscopes of subheading 9030.10 for accurate impedance matching.
Deskliew Deskew Fixture for Probes
A deskew calibration fixture for dual-probe channel timing alignment in oscilloscopes, generating simultaneous signals via SMB. This fixture is essential for accurate differential measurements with oscilloscopes of subheading 9030.10.