Oscilloscope Front Panel Protection Cover
A custom-molded protective cover designed to shield oscilloscope BNC inputs and controls from dust and moisture during storage. It is model-specific for major oscilloscope brands and serves as a protective accessory. As an accessory for oscilloscopes of heading 90.30, it falls under tariff item 9030.90.00.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | — | Free |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If the cover is a generic protective case not specific to oscilloscopes
A general-purpose plastic cover would be classified as an article of plastics rather than as an oscilloscope accessory.
If the cover is a carrying case with a rigid outer surface
Cases and containers of a kind normally carried in the pocket or handbag could fall under heading 42.02.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Declare the cover as an accessory for oscilloscopes under 9030.90.00, ensuring it is not a general-purpose case
• If the cover is made of plastics, confirm it is not classified under Chapter 39 as a general-use article
• Keep the model compatibility information to demonstrate it is specifically designed for oscilloscopes
Related Products under Tariff item 9030.90.00
4-Channel Analog Front-End PCA for Benchtop Scopes
A multi-channel printed circuit assembly with track/hold amplifiers and 12-bit ADCs, designed specifically for 4-channel benchtop oscilloscopes up to 500MHz. This PCA is a dedicated part for oscilloscopes of subheading 9030.10, as it conditions and digitizes analog signals for measurement.
9030.82 Ionizing Radiation Control PCA
A control printed circuit assembly for apparatus detecting cosmic and other ionizing radiations under heading 90.30. It manages power, data acquisition, and alarms for radiation detection instruments. As a dedicated part for ionizing radiation measurement apparatus, it falls under tariff item 9030.90.00.
Active FET Oscilloscope Probe
A low-noise active FET probe for high-impedance oscilloscope measurements up to 1GHz bandwidth, powered via scope auxiliary port. This probe is an accessory for oscilloscopes of subheading 9030.10, enhancing measurement capabilities.
Bertscope Bit Error Rate PCA
A printed circuit assembly for bit error rate testing in high-speed oscilloscopes of heading 90.30. It generates patterns and measures electrical eye diagrams for signal integrity analysis. As a dedicated part for oscilloscopes, it is classified under tariff item 9030.90.00.
BNC Feedthrough Termination 50 Ohm
A 50-ohm BNC feedthrough terminator for oscilloscope inputs, preventing signal reflections and protecting front-end amplifiers. This accessory is used with oscilloscopes of subheading 9030.10 for accurate impedance matching.
Deskliew Deskew Fixture for Probes
A deskew calibration fixture for dual-probe channel timing alignment in oscilloscopes, generating simultaneous signals via SMB. This fixture is essential for accurate differential measurements with oscilloscopes of subheading 9030.10.