For use in Canadian manufactures
Copper tube or pipe fittings (for example, couplings, elbows, sleeves). > Of copper alloys > Pressure type: > For use in Canadian manufactures
Duty Rate (from China)
Products classified under Tariff item 7419.20.91.00
Cast Bronze Marine Propeller Hub
A sand-cast marine propeller hub made of copper-tin bronze alloy. It is in a rough cast state without machining or balancing, qualifying as a cast article of copper alloy not further worked.
7419.20.91Cast Copper Alloy Pump Impeller
An investment-cast bronze impeller for centrifugal pumps, supplied in rough cast condition without blade balancing. It is a cast article of copper alloy not further worked, suitable for Canadian manufacturers.
7419.20.91Cast Copper Bearing Bushing
Centrifugally cast copper alloy bushings for heavy equipment bearings, in rough-cast form without boring or oil grooves. These are cast articles of copper alloy not further worked, intended for Canadian manufacturing.
7419.20.91Cast Copper Ornamental Grille
Sand-cast copper-zinc grilles for architectural decoration, in raw casting form without cleaning or installation fittings. These are cast articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Copper Alloy Door Hinge Casting
A die-cast copper-zinc alloy door hinge, produced without further machining or finishing. It is a cast article of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Forged Brass Lock Cylinder Blank
Hot-forged brass blanks for pin tumbler lock cylinders, without keyway cutting or finishing. These are forged articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Forged Copper Anode Blank
Upset-forged high-purity copper blanks for electroplating anodes, without rack attachments. These are forged articles of copper not further worked, for use in Canadian manufacturing.
7419.20.91Forged Copper Bell Blank
Hand-forged copper alloy blanks for musical or decorative bells, rough-formed without tuning or lathing. These are forged articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Forged Copper Faucet Valve Body
Drop-forged copper alloy body for plumbing valves, left in rough form without machining internal threads or surfaces. It is a forged article of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Molded Copper Heat Sink Base
Die-molded copper alloy base plates for electronic heat sinks, formed without fin machining or surface finishing. These are molded articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Molded Copper RF Shielding Can
Die-molded copper cans for EMI/RF shielding in electronics, deep-drawn without seams soldered or trimmed. These are molded articles of copper not further worked, for use in Canadian manufacturing.
7419.20.91Stamped Brass Shim Stock
Precision stamped brass shims for machinery alignment, produced in coils or sheets without slitting or perforating. These are stamped articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Stamped Copper Bracket for Machinery
A stamped brass bracket for supporting machinery components, created by precision stamping from copper-zinc sheet without subsequent bending or finishing. It is a stamped article of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Stamped Copper Electrical Terminal
Precision stamped copper-zinc terminals for wiring harnesses, produced by progressive die stamping without forming or plating. These are stamped articles of copper alloy not further worked, for use in Canadian manufacturing.
7419.20.91Stamped Copper Nameplate Blank
Stamped brass blanks for equipment nameplates, deep-drawn without engraving or printing. These are stamped articles of copper alloy not further worked, for use in Canadian manufacturing.