FeSiMn Briquettes 50kg for Foundries
Ferro-silico-manganese compressed into 50 kg briquettes for easier handling in small foundries. The composition (65% Mn, 17% Si) meets the definition of ferro-alloys under Chapter 72, and briquetting is a physical form change that does not alter its classification.
Import Duty Rates by Country of Origin
| Origin Country | MFN Tariff | Surtaxes | Total Effective Rate |
|---|---|---|---|
| 🇨🇳China | Free | — | Free |
| 🇲🇽Mexico | Free | — | Free |
| 🇺🇸United States | Free | — | Free |
| 🇩🇪Germany | Free | — | Free |
| 🇯🇵Japan | Free | — | Free |
More Specific Codes
This product may fall under a more specific subheading:
Alternative Classifications
This product could be classified differently depending on its characteristics or intended use.
If the briquettes contain a binder that makes them a composite product rather than a simple agglomerated ferro-alloy.
Briquettes with organic or other binders may be classified as other ferro-alloys if the binder changes the essential character.
Not sure which classification is right?
The Tariff Assistant works through the GRI rules on your specific product to reach the right tariff item — and can price the duty on it in the same conversation.
Import Tips & Compliance
• Ensure the briquettes are declared as ferro-silico-manganese (7202.30.00) and not as waste or scrap
• Keep mill certificates showing Mn and Si content to support classification
• Verify if the briquettes contain any binder that could affect the alloy's composition
Related Products under Tariff item 7202.30.00
FeSiMn Granules 3-10mm HC FeMn Substitute
Granulated ferro-silico-manganese sized 3-10 mm, used as an economical substitute for high-carbon ferromanganese in carbon steels. It provides both manganese alloying and silicon deoxidation, and the granulated form is a physical state covered by the ferro-alloy definition.
FeSiMn Lumps 10-50mm Grade A
Ferro-silico-manganese in lump form sized 10-50 mm, standard Grade A with 65% min manganese and 16% min silicon. Used in steel foundries for simultaneous deoxidation and manganese addition, and the lump form is typical for ferro-alloys.
FeSiMn Powder -200 Mesh for Welding
Atomized ferro-silico-manganese powder passing a 200 mesh sieve, used in flux-cored welding wires and metal powder production. Powdering is a physical process that does not change the alloy's classification as ferro-silico-manganese.
High-Silicon Ferrosilicon Manganese FeSiMn68Si20
A grade of ferro-silico-manganese containing 68% manganese and 20% silicon, used in the production of low-carbon steels and stainless steels. It simultaneously provides manganese and silicon, meeting the definition of ferro-silico-manganese.
Low-Phosphorus FeSiMn65Si16 P0.03
Ultra-low phosphorus ferro-silico-manganese (P≤0.03%) with 65% Mn and 16% Si, essential for high-quality pipe and boiler steels. The low phosphorus content does not change its classification as ferro-silico-manganese.
Medium-Carbon Ferrosilicon Manganese FeSiMn70Si14C1.5
Ferro-silico-manganese alloy with 70% manganese, 14% silicon, and 1.5% carbon, commonly used in welding electrodes and structural steel production. The carbon content is within the range for ferro-silico-manganese, and it is definitively classified under this item.